AIROSOL COMPANY, INC.
MCKAY CHEMICALS
MECHANICS BRAND
11th &
MATERIAL
SAFETY DATA SHEET
|
PRODUCT NAME: |
COOLING SYSTEM FAST
FLUSH |
Hmis
Codes: |
H |
F |
R |
P |
|
PRODUCT CODE: |
50810 |
|
|
|
|
|
|
ISSUE DATE |
|
|
1 |
2 |
0 |
0 |
|
SECTION I - MANUFACTURER
IDENTIFICATION |
|
MANUFACTURER’S NAME: |
Airosol Company, Inc. |
|
ADDRESS: |
|
|
EMERGENCY PHONE: |
1-800-535-5053 |
|
INFORMATION PHONE: |
1-800-633-9576 |
|
DATE REVISED: |
|
|
SECTION I I-
HAZARDOUS INGREDIENTS/SARA III INFORMATION |
OCCUPATIONAL
EXPOSURE LIMITS
|
HAZARDOUS COMPONENTS |
CAS NUMBER |
% |
OSHA |
ACGIH |
|
|
Sodium Tripolyphosphate |
7758-29-4 |
1-3 |
15
mg/m3 |
10
mg/m3 |
|
|
Sodium acid pyrophosphate |
7758-16-9 |
1-3 |
N/A |
N/A |
|
|
|
|
|
|
|
|
|
SECTION III- PHYSICAL/CHEMICAL
CHARACTERISTICS |
|
BOILING POINT: |
ND |
SPECIFIC GRAVITY: |
1.0-1.1 |
|
VAPOR DENSITY: |
NA |
EVAPORATION RATE: |
NA |
|
APPEARANCE AND ODOR: |
milky white grainy liquid |
SOLUBILITY IN WATER: |
approximately 90% |
|
SECTION IV- FIRE AND EXPLOSION
HAZARD DATA |
|
FLASH POINT: |
ND |
METHOD USED: |
ND |
|
FLAMMABLE LIMITS IN AIR BY VOLUME: ND |
LOWER: |
NA |
UPPER: |
NA |
|
|
EXTINGUISHING MEDIA: Carbon dioxide, dry chemical or foam. |
|||||
|
SPECIAL FIREFIGHTING PROCEDURES: Avoid using direct water stream. Wear self-contained breathing apparatus and
full fire fighting protective clothing.
Only use water spray to keep nearby containers cool
. Remove sources of
ignition. |
|
|
UNUSUAL FIRE AND EXPLOSION
HAZARDS: Use SCBA and thermal
protective clothing. Use carbon
dioxide, dry chemical, or water spray to extinguish fires. |
|
|
SECTION V- REACTIVITY DATA |
|
STABILITY: Stable |
|
CONDITIONS TO AVOID: Presence of incompatible materials and
ignition sources. |
|
INCOMPATIBILITY (MATERIALS TO
AVOID): Strong oxidizing agents. |
|
HAZARDOUS DECOMPOSITION OR
BYPRODUCTS: Combustion products include carbon dioxide and carbon monoxide. |
Page
1
|
PRODUCT NAME: |
COOLING SYSTEM FAST FLUSH |
|
PRODUCT
CODE: |
50810 |
|
SECTION V- REACTIVITY DATA
(continued) |
|
HAZARDOUS POLYMERIZATION: Will not
occur. |
|
SECTION VI- HEALTH HAZARD DATA |
EFFECTS
OF OVER EXPOSURE:
|
EYES:
Avoid eye contact. Eye contact
is not expected to cause permanent damage.
If heated product contacts eye, seek medical attention immediately for
thermal burn treatment. |
|
SKIN:
Avoid skin contact. Infrequent
skin contact is not expected to cause damage to skin. Repeated or prolonged skin contact may
cause a skin sensitization effect in susceptible individuals. Good hygiene practice demands minimal
dermal contact. Hot product will cause
burns to skin. |
|
INGESTION: Do not ingest. Aspiration of product or vomits of
swallowed liquid may cause chemical pneumonitis. Ingestion of small amounts is not likely to
cause acute toxicity or internal damage. |
|
INHALATION: Short term inhalation of concentrated
mist/vapor from product may cause dizziness, nausea, and respiratory tract
congestion in some individuals. Single
exposure to oily mist/vapors is not expected to cause acute toxicity. |
|
EMERGENCY
AND FIRST AID PROCEDURES: |
|
DIGESTION: CALL A PHYSICIAN OR |
|
INHALATION: Remove patient to fresh air. Get medical attention. |
|
SKIN
AND EYE CONTACT: |
|
EYES:
Immediately flush eyes with large amounts of water for at least 15
minutes. Hold eyelids apart to ensure
complete flushing. Do not attempt to
neutralize with chemical agents. Get
medical help immediately. |
|
SKIN:
Remove contaminated clothing and flush skin with water. Wash with soap and water until material has
been removed. Seek medical attention. |
|
SECTION VII- PRECAUTIONS FOR
SAFE HANDLING AND USE |
|
STEPS TO BE TAKEN IN CASE LARGE
AMOUNT OF MATERIAL IS RELEASED OR SPILLED:
Remove all sources of ignition, avoid breathing vapors and remove with
inert absorbent. Recover all possible
material for reclamation. |
|
WASTE DISPOSAL METHOD: Dispose of in accordance with federal,
state, and local regulations regarding pollution. |
|
PRECAUTIONS TO BE TAKEN IN HANDLING
AND STORING: Keep away from heat,
sparks, or open flame. Do not use
container for any other purpose. |
|
OTHER PRECAUTIONS: NA. |
|
SECTION VIII- CONTROL MEASURES |
|
RESPIRATORY PROTECTION: Usually not required if it is used as it is
described on the label. |
|
VENTILATION: Provide adequate ventilation to keep vapors
below allowable exposure levels. |
|
PROTECTIVE GLOVES: For prolonged or repeated contact, wear
gloves which are recommended by glove supplier for protection against
materials in Section II. |
|
EYE PROTECTION: Recommend safety glasses with unperforated sideshields. |
|
OTHER PROTECTIVE CLOTHING OR
EQUIPMENT: Long sleeves and long
pants. |
|
WORK/HYGIENIC practices: |
Page
2
|
PRODUCT NAME: |
COOLING SYSTEM FAST FLUSH |
|
PRODUCT
CODE: |
50810 |
|
SECTION IX- REGULATORY
INFORMATION |
SUPERFUND AMENDMENTS AND REAUTHORIZATION ACT OF 1986 (SARA)
TITLE III:
CHEMICAL CAS NUMBER CONCENTRATION
%
None
listed
FEDERAL EPA:
Comprehensive Environmental Response, Compensation and Liability Act of
1980 (CERCLA) requires the notification of the
CHEMICAL CAS NUMBER CONCENTRATION
% RQS IN #’s
None
listed
Sodium Tripolyphosphate 7758-29-4
Sodium Tripolyphosphate 7758-29-4
NEW
Sodium Tripolyphosphate 7758-29-4
TOXIC SUBSTANCES CONTROL ACT (TSCA) STATUS: Listed
NFPA RATING AS AN AEROSOL:
NA
|
SECTION X- DISCLAIMER |
NOTE:
THE INFORMATION IN
THIS DOCUMENT IS BELIEVED TO BE CORRECT AS OF THE DATE ISSUED. HOWEVER, NO WARRANTY OF MERCHANTABILITY,
FITNESS FOR ANY PARTICULAR PURPOSE, OR ANY OTHER WARRANTY IS EXPRESSED OR TO BE
IMPLIED REGARDING THE ACCURACY OR COMPLETENESS OF THIS INFORMATION OR THE
PRODUCT, THE SAFETY OF THIS PRODUCT, OR THE HAZARDS RELATED TO ITS USE. THIS INFORMATION AND PRODUCT ARE FURNISHED
"AS IS" AND
ON THE CONDITION THAT THE PERSON RECEIVING THEM SHALL MAKE THEIR OWN
DETERMINATION AS TO THE SUITABILITY OF THE PRODUCT FOR THEIR PARTICULAR PURPOSE
AND ON THE CONDITION THEY ASSUME THE RISK OF THEIR USE THEREOF.
Page
3