AIROSOL COMPANY, INC.
MCKAY CHEMICALS
MECHANICS BRAND
1101
MATERIAL
SAFETY DATA SHEET
|
PRODUCT NAME: |
Transmission Stop Leak 12 oz |
Hmis
Codes: |
H |
F |
R |
P |
|
PRODUCT CODE: |
50103mb |
|
0 |
1 |
0 |
0 |
|
SECTION I - MANUFACTURER
IDENTIFICATION |
|
MANUFACTURER’S NAME: |
Airosol Company, Inc. |
|
ADDRESS: |
|
|
EMERGENCY PHONE: |
1-800-535-5053 |
|
INFORMATION PHONE: |
1-800-633-9576 |
|
DATE REVISED: |
|
|
SECTION I I- HAZARDOUS
INGREDIENTS/SARA III INFORMATION |
OCCUPATIONAL
EXPOSURE LIMITS
|
HAZARDOUS COMPONENTS |
CAS NUMBER |
OSHA |
ACGIH |
|
% |
|
Severely Hydrotreated Heavy
Naphthenic Petroleum Oil |
64742-52-5 |
5 mg/m3 |
5 mg/m3 |
|
92-98 |
If used in
applications where a mist may be generated, observe a TWA/PEL of 5 mg/m3 for
mineral oil mist.
*All chemical
compounds marked with an Asterisk (*) are toxic chemicals subject to the
reporting requirements of Section 313 of Title III of the Superfund Amendments
and Reauthorization Act (SARA) of 1985 and 40 CFR Part 372. You must notify each person to whom this
mixture or trade name product is sold.
This statement must remain a part of this Material Safety Data Sheet.
|
SECTION III- PHYSICAL/CHEMICAL
CHARACTERISTICS |
|
BOILING POINT: |
IBT > 550°F |
SPECIFIC GRAVITY: |
0.903 @ 77°F |
|
VAPOR DENSITY: |
> 5 (Air = 1) |
EVAPORATION RATE: |
1000 x slower than ethyl ether |
|
APPEARANCE AND ODOR: |
Red, mineral oil odor |
SOLUBILITY IN WATER: |
Insoluble |
|
SECTION IV- FIRE AND EXPLOSION
HAZARD DATA |
|
FLASH POINT: |
320°F |
METHOD USED: |
COC |
|||
|
FLAMMABLE LIMITS IN AIR BY VOLUME: |
LOWER: |
NE |
UPPER: |
NE |
||
|
EXTINGUISHING MEDIA: |
Dry chemical, foam, carbon dioxide,
and water foam. Water can be used to cool and protect exposed material. |
|
SPECIAL FIREFIGHTING PROCEDURES: Wear self-contained breathing apparatus and
full protective clothing. |
|
|
UNUSUAL FIRE AND EXPLOSION HAZARDS: heat,
dense smoke. |
Toxic fumes, gases or vapors may
evolve on burning or exposure to |
|
SECTION V- REACTIVITY DATA |
|
STABILITY: Material is normally stable at moderately
elevated temperature and pressure. |
|
CONDITIONS TO AVOID: Sources of
ignition. |
Page
1 of 3
|
PRODUCT
NAME: |
Transmission
Stop Leak |
|
PRODUCT
CODE: |
50103mb |
|
SECTION V- REACTIVITY DATA
(continued) |
|
INCOMPATIBILITY (MATERIALS TO
AVOID): Strong oxidizing agents. |
|
HAZARDOUS DECOMPOSITION OR
BYPRODUCTS: Smoke, carbon monoxide,
aldehydes and other products of incomplete combustion. Under combustion conditions, sulfur oxide
will be formed. |
|
HAZARDOUS POLYMERIZATION: Will not occur. |
|
SECTION VI- HEALTH HAZARD DATA |
|
INHALATION HEALTH RISKS AND SYMPTOMS
OF EXPOSURE: Negligible hazard at
ambient temperature (0 to 100°F, -18 to 38°C). Avoid breathing vapors or mists. |
NATURE
OF HAZARD:
|
EYES: |
Minimal irritation upon contact. |
|||
|
SKIN: |
May cause mild skin irritation with
prolonged and repeated contact. |
|||
|
INGESTION: |
Low order of acute oral toxicity. |
|||
|
CARCINOGENICITY: |
NTP? |
IARC? |
OSHA REGULATED? |
|
None listed
|
MEDICAL CONDITIONS GENERALLY
AGGRAVATED BY EXPOSURE: NA |
|
EMERGENCY
AND FIRST AID PROCEDURES: |
|
|
INHALATION: Using proper respiratory protection,
immediately remove the affected victim from exposure. Administer artificial respiration if
breathing is stopped. Keep at rest. Call for prompt medical attention. |
|
|
INGESTION: |
Do not induce vomiting. If conscious, give two (2) glasses of
water. Get immediate medical
attention. |
|
SKIN
AND EYE CONTACT: |
|
EYES:
Immediately flush eyes with large amounts of water for at least 15
minutes. If irritation persists, get
medical attention immediately. |
|
SKIN: Wash with soap and water. Remove contaminated clothing. If irritation develops, get medical
attention. Launder contaminated
clothing before reuse. |
|
STEPS TO BE TAKEN IN CASE MATERIAL IS
RELEASED OR SPILLED: Eliminate sources
of ignition. Prevent additional
discharge of material, if possible to do so without hazard. For small spill, implement cleanup
procedures and, if in public area, keep public away and advise
authorities. Prevent liquid from
entering sewers, watercourses, or low areas.
Contain spilled liquid with sand or earth. |
|
SECTION VII- PRECAUTIONS FOR
SAFE HANDLING AND USE |
|
WASTE DISPOSAL METHOD: Dispose in accordance with federal, state,
and local regulations regarding pollution. |
|
PRECAUTIONS TO BE TAKEN IN HANDLING
AND STORING: Keep away from heat,
sparks, or open flame. |
|
OTHER PRECAUTIONS: NA. |
|
SECTION VIII- CONTROL MEASURES |
|
RESPIRATORY PROTECTION: Usually not required but use with adequate
ventilation if used as described on the label. |
|
VENTILATION: Provide adequate ventilation to keep mist
or vapors below allowable exposure levels. |
|
PROTECTIVE GLOVES: For prolonged or repeated contact, wear
gloves made of
nitrile, neoprene, poly vinly alcohol, poly vinyl
chloride, or viton.. |
Page
2 of 3
|
PRODUCT
NAME: |
Transmission
Stop Leak |
|
PRODUCT
CODE: |
50103mb |
|
SECTION VIII- CONTROL MEASURES
(continued) |
|
EYE PROTECTION: Recommend safety glasses with unperforated
sideshields. |
|
OTHER PROTECTIVE CLOTHING OR
EQUIPMENT: Long sleeves and long
pants. |
|
WORK/HYGIENIC PRACTICES: |
|
SECTION IX- DISCLAIMER |
|
DISCLAIMER: The information in this document is believed to be correct as of
the date issued. However, no warranty
of merchantability, fitness for any particular purpose, or any other warranty
is expressed or to be implied regarding the accuracy or completeness of this
information or the product, the safety of this product, or the hazards
related to its use. This information
and product are furnished "as is" and on the condition that the person
receiving them shall make their own determination as to the suitability of
the product for their particular purpose and on the condition that they
assume the risk of their use thereof.
|
Page 3 of 3